Recording on a Computer

How to Record a Voiceover at Home on a Budget

Record a clean voiceover at home on a budget: choose a mic and interface, treat a small space, set levels and do a light cleanup. Practical steps.

On this page
  1. Quick answer
  2. Budget gear
  3. Pick a quiet, dry space
  4. Mic placement and pop control
  5. Levels and noise floor
  6. Room tone
  7. Recording format
  8. A basic cleanup chain
  9. Free software
  10. Checklist before you record
  11. Common mistakes
  12. Related guides

Quick answer

A convincing voiceover needs three things: a microphone that suits your room, a quiet and dry space, and careful levels. You don’t need expensive gear to start. A dynamic microphone with an audio interface, a closet full of clothes or a room with soft furnishings, and free software such as Audacity or Ocenaudio will cover most budget voiceovers. Record 24-bit WAV, then clean up gently.

Budget gear

Microphone. Two common options in the budget range:

  • Dynamic microphones, such as the Samson Q2U or Audio-Technica ATR2100x-USB (roughly $60 to $100; prices vary). They pick up less room sound, which helps in an untreated room.
  • Condenser microphones, such as the Audio-Technica AT2020 or AT2020USB-X (roughly $100 to $150; prices vary). They’re more sensitive and detailed, but they also pick up more room noise and echo.

In a noisy or echoey room, a condenser often sounds worse than a dynamic.

Interface. For an XLR microphone, an interface gives you a preamp and a headphone output. The Behringer UMC22 (about $50) and the Focusrite Scarlett Solo (about $130 to $150) are common budget choices. Prices vary.

Headphones. Closed-back headphones, such as the Sony MDR-7506 or Audio-Technica ATH-M40x or M50x, stop sound leaking back into the microphone.

Pick a quiet, dry space

Reflections are the main problem in a home voiceover. Choose the smallest room you have that has soft surfaces:

  • A closet full of clothes works surprisingly well.
  • Hang blankets, duvets or moving blankets around the microphone, out of shot if you’re filming.
  • Rugs, curtains and sofas absorb sound.

Thin acoustic foam or egg-crate foam doesn’t soundproof a room. It only reduces some reflections. Noise reduction tools can’t remove room echo either, so treat the room before you rely on processing.

Mic placement and pop control

  • For close voiceover-style sound, start about 4 to 8 inches (10 to 20 cm) from the microphone. Adjust in small steps.
  • Angle the microphone slightly off-axis to reduce plosives (hard P and B sounds).
  • Use a pop filter or foam windscreen between your mouth and the microphone.
  • Keep your distance consistent, since moving changes the tone.

Levels and noise floor

  • Record peaks around -12 dBFS, with average speech around -18 to -20 dBFS.
  • Keep the noise floor at -60 dB or quieter. That’s the ACX target for audiobooks, and it’s a sensible goal for any voiceover.
  • Turn off air conditioning, fridges, fans and phone notifications before you record.

Room tone

Record 10 to 30 seconds of silence in the same spot, with the same gain setting, before you start. Room tone helps fill gaps in editing, and it can serve as a noise profile for noise reduction later.

Recording format

Record WAV at 24-bit and 48 kHz. That leaves room for editing. Keep the masters as WAV, and export a lossy copy such as MP3 only for delivery.

A basic cleanup chain

Keep processing light, and listen after each step:

  1. High-pass filter at around 80 to 100 Hz to remove rumble.
  2. Light noise reduction, using your room tone. Stop before it sounds watery.
  3. Gentle EQ to reduce boxiness or harshness, if needed.
  4. Compression at around 3:1 to even out the level.
  5. Limiter at -1 to -3 dB to catch peaks.

Free software

  • Audacity (Windows, macOS, Linux) is free and covers everything above. It also has an ACX Check analyzer.
  • GarageBand (Mac) is free and has simple editing.
  • Ocenaudio (Windows, macOS, Linux) is free and has real-time effect previews.
  • Reaper has a 60-day full trial. After that, it needs a paid license.

For audiobook specifications, see audiobook recording software.

Checklist before you record

  • The room is quiet, and noisy appliances are off.
  • Microphone distance is consistent, and the pop filter is in place.
  • Headphones are on, and you can hear the microphone clearly.
  • Peaks sit around -12 dBFS.
  • Room tone is recorded.
  • The file is set to 24-bit WAV at 48 kHz.

Common mistakes

  • Buying an expensive microphone to fix a bad room. An expensive mic won’t fix echo.
  • Assuming a condenser is always better. In noisy, echoey rooms, it often sounds worse.
  • Hoping foam panels will soundproof the room. They reduce some reflections only.
  • Relying on noise reduction to remove echo. It can’t do that well.

For a general look at computer and microphone recording, see the computer audio recording guide. If your voiceover is for a video, check the YouTube audio requirements before you export.

The complete guide to recording on a computer

How to Record High-Quality Audio on Your Computer
Read the guide

Keep exploring

Guides from other topics

All topics →