Recording on a Computer

OBS Audio Filters for Better Recordings

Set up OBS audio filters for clear voice: noise suppression, gate, compressor, limiter and EQ, with starting values, filter order and monitoring tips.

On this page
  1. Quick answer
  2. How OBS runs filters
  3. A starting chain
  4. Noise suppression
  5. Noise gate
  6. Compressor
  7. Limiter and levels
  8. EQ and gain
  9. Tune while you listen
  10. Keep a raw track
  11. Common mistakes
  12. Your questions
  13. Related guides

Quick answer

Add filters to your microphone source in OBS’s Audio Mixer. Filters run from top to bottom, so order matters. A common voice chain is noise suppression, then a noise gate, EQ, a compressor and a limiter. Adjust each filter by ear while you monitor your voice, and keep the peaks out of the red.

How OBS runs filters

Click the gear (or three-dot) icon on a source in the Audio Mixer, choose Filters, and click +. OBS applies the filters in the order they’re listed, from top to bottom. Each filter passes its output to the next, so a limiter placed before a compressor behaves differently from one placed after it.

Guides disagree about the best order. Some put the compressor first and others last. There isn’t a single correct answer. The right chain depends on your microphone, room and voice, so test each change by listening.

A starting chain

  1. Noise suppression to reduce constant hiss or hum.
  2. Noise gate to mute pauses and clicks between words.
  3. EQ to clean up low rumble and tone.
  4. Compressor to even out the level.
  5. Limiter as a final ceiling on peaks.

A gain filter is also available. Use it to nudge the level, but remember that raising the gain raises the noise too.

Noise suppression

OBS offers three methods:

  • RNNoise usually gives the best quality with low CPU use.
  • Speex is lighter and has an adjustable suppression level.
  • NVIDIA Noise Removal needs an NVIDIA RTX GPU and NVIDIA’s audio effects SDK.

Heavy suppression makes a voice sound robotic or warbly. For tools beyond OBS, see AI noise removal tools compared. Start light, and increase the setting only until the hiss is gone.

Noise gate

A gate mutes the signal when the level drops below a threshold. OBS’s defaults are a close threshold of -32 dB, an open threshold of -26 dB, an attack of 25 ms, a hold of 200 ms and a release of 150 ms.

Set the open threshold just above your room’s noise and below your quietest speech. If it’s set too high, it can clip the ends of words. A gate mutes pauses and clicks, but it doesn’t remove noise that sits underneath your speech. For that, use suppression or treat the room.

Compressor

OBS’s default compressor is a 10:1 ratio, a -18 dB threshold, a 6 ms attack, a 60 ms release and 0 dB output gain. For most voices, 10:1 is too aggressive (see vocal compression settings). Start around 3:1 to 4:1 with a threshold of roughly -18 to -24 dB. Then add output gain to bring back the level the compressor took away.

Limiter and levels

The limiter’s default threshold is -6 dB with a 60 ms release. Set it roughly between -1 and -6 dB, so loud moments can’t clip.

A reasonable target is speech peaking in the mixer’s yellow zone, around -20 to -10 dB on the meter. Red means you’re close to clipping. Some streamers aim a little higher, so check your own meter and listen back.

EQ and gain

Newer OBS versions include a 3-band equalizer. Use it to turn down low rumble and to tame harsh or boxy tones. It has no high-pass filter, so for a high-pass around 80 Hz (a common starting point), use a VST EQ.

You can also load VST plugins with the VST 2.x Plug-in filter. Free options such as ReaPlugs’ ReaEQ work well. For more, see the best free equalizer VST plugins. VST3 support depends on your OBS version.

Tune while you listen

To hear your filtered voice live:

  1. Click the gear icon on your microphone source and choose Advanced Audio Properties.
  2. Set Audio Monitoring to Monitor Only. You’ll hear the filtered sound in your headphones without sending it to the stream or recording.
  3. Adjust one filter at a time while you speak in your normal voice.
  4. Set monitoring back to Monitor Off before you go live, so you don’t hear yourself or cause feedback.

Use headphones while monitoring. Speakers can feed back into the microphone.

Keep a raw track

Filters apply to the source, so the recording carries the processed sound. Filters can’t be removed from a finished recording. If you want an unprocessed backup, add a second copy of your microphone source without filters, or record separate tracks. See how to record separate audio tracks in OBS.

Common mistakes

  • Too much noise suppression. It makes the voice robotic.
  • Expecting a noise gate to remove noise under speech. It only mutes pauses.
  • Keeping the default 10:1 compressor. It’s too aggressive for most voices.
  • Stacking many filters without listening. Make one change at a time.

Your questions

What are the best OBS audio settings for streaming?

Match the sample rate across your devices, set the microphone gain so speech peaks sit in the yellow zone, and use a short chain such as suppression, gate and limiter. The right values depend on your microphone and room, so test with a short recording.

How do you keep music from being picked up?

Desktop Audio captures everything your computer plays. On Windows 10 (version 2004 or later) and Windows 11, use the Application Audio Capture source to record only the apps you choose. Leave your music player out of that source.

Can you add filters to OBS?

Yes. Filters are added to each source from the Audio Mixer’s Filters menu. Several are built in, and VST plugins can be added with the VST filter.

How do you add audio effects in OBS?

Use the same Filters menu. Built-in effects include gain, EQ, compressor and limiter. For more options, load a VST plugin.

For uploading your finished stream or video, see YouTube audio requirements. For a wider look at setting up computer audio, see the computer audio recording guide.

The complete guide to recording on a computer

How to Record High-Quality Audio on Your Computer
Read the guide

Keep exploring

Guides from other topics

All topics →