Use a send when several tracks should share the same space, and use an insert when a single track needs its own effect. Sends are the usual choice for mixing reverb, because one reverb can serve many tracks and keep them in the same room.
Inserts vs sends
- Insert: the reverb sits in series on the track. You set the amount with the plugin’s dry/wet mix.
- Send: the track feeds an aux or FX bus, where a reverb is set to 100% wet. The send level sets how much of the reverb each track gets.
When you set a send’s return, put the reverb at 100% wet, then adjust the amount with the send knobs. Turning down the return’s dry/wet can leave you working against the wrong control.
Pre-fader and post-fader sends
Post-fader sends are the default for effects. They keep the reverb in proportion to the track’s fader, so if you lower a vocal, its reverb drops with it.
Pre-fader sends are for headphone or monitor mixes, or for special effects where the reverb should ignore the fader. A reverb in the headphone mix is also the basis of hybrid monitoring, where the singer hears the dry voice directly from the interface.
Why sends are the usual choice
- One reverb serves many tracks. Sharing a reverb glues the tracks into one space.
- Saves CPU. You run one reverb instead of one per channel.
- Easier to control. Changing the return changes the whole room at once.
A common setup is one to three reverbs: a short room, a plate and a long hall. Each one gives a different sense of space.
Stop the mud
Mud usually builds in the 200 to 500 Hz range, and reverb on bass and kick adds to it. To keep the return clean:
- High-pass the return around 150 to 300 Hz.
- Low-pass the return around 6 to 10 kHz to cut hiss and harshness.
- Keep kick and bass mostly dry. Reverb on the low end pushes it into the background, which usually works against the mix.
For more on cutting low end, see what a high-pass filter is in audio.
Pre-delay, decay and tempo
- Pre-delay of 20 to 80 ms separates the dry vocal from its reverb, so the vocal stays clear.
- Typical decay: rooms 0.3 to 1 s, vocal plates 1.5 to 2.5 s, halls 2 to 3+ s. These vary by tempo and genre.
- Tempo sync: one beat in milliseconds is 60,000 ÷ BPM. At 120 BPM, a beat is 500 ms, and a 1/16 note is 125 ms.
Duck the reverb
Sidechain-duck the reverb return by about 2 to 4 dB from the dry vocal. The reverb then drops out when the vocal plays and comes back in the gaps, so the vocal stays clear without losing its space.
When an insert is right
Inserts suit effects that belong to one track:
- A gated reverb on a snare
- A spring reverb on a guitar amp
- A creative wash on a single sound
Common mistakes
- Expecting an insert at 100% wet to keep the dry signal. At 100% wet, the dry signal is gone. Use a lower wet setting to blend.
- Thinking sends sound different. They’re a different way of routing, not a different sound. They offer control and efficiency.
- Adding more reverb for more depth. Level, EQ and pre-delay matter more than the amount.
- Judging reverb solo. Reverb that sounds right on its own is usually too much in the full mix.
For more on balancing a mix, see home mixing basics.