Short answer
Neither rate is better for music you can hear. Both are well above the upper limit of human hearing. Pick based on where the music will go. Use 44.1 kHz for CD and music-only work. Use 48 kHz if the music will sit alongside video, film, TV or games. Whichever you choose, keep the project, interface and export at the same rate.
Why there are two standards
44.1 kHz is the CD standard (Red Book). Its Nyquist limit is 22.05 kHz. 48 kHz is the standard for video, film and broadcast, with a limit of 24 kHz. The two rates grew out of different industries, not from a difference in how they sound.
What each rate can capture
Human hearing reaches about 20 kHz at best, and the upper limit usually drops with age. Both rates capture everything below that, with room left for the anti-aliasing filter. 48 kHz leaves a slightly wider gap between the top of the audible range and the filter cutoff. That eases filter design, but it’s a small engineering benefit, not an audible one.
Can you hear the difference?
In blind tests, listeners generally can’t reliably tell 44.1 kHz from 48 kHz at the same bit depth. Modern sample-rate conversion in major DAWs is effectively transparent, so converting between the two rates usually doesn’t cause an audible loss.
Converting up doesn’t add detail. Turning 44.1 kHz material into 48 or 96 kHz doesn’t add information that wasn’t there. If you have to convert, converting down is the safer direction.
Pick 44.1 kHz when
- The final product is a CD or a music-only release.
- You’re working with collaborators, or on a project that already runs at 44.1 kHz.
- The music won’t be used with picture.
Many streaming music catalogs are 44.1 kHz, and streaming services resample as needed.
Pick 48 kHz when
- The music will be used with video, film, TV, games or online video. YouTube’s audio requirements, for example, list 48 kHz.
- You’re recording audio that will be synced to picture.
- You want to avoid a later conversion for video work.
If you record at 44.1 kHz and the music later goes into a video, you’ll need to convert it. Conversion is usually transparent, but it’s one more step to track.
Files at 48 kHz are about 8.8% larger than 44.1 kHz files at the same bit depth. That’s a minor consideration.
The rule that matters most
Keep one sample rate for the whole project. Mixing rates causes resampling, or pitch and speed errors. For example, playing 44.1 kHz audio at 48 kHz without conversion runs about 8.8% fast and roughly 1.5 semitones sharp. Set the rate in your interface’s control panel as well as the DAW; in FL Studio, that’s covered in the audio settings guide. Mismatched rates also cause slow drift when you record internal audio on a Mac.
Bit depth matters more for headroom than this choice does. For that, see bit depth explained.
Common mix-ups
- “48 kHz is hi-res.” It’s often grouped under high resolution, but the label says little about what you’ll hear.
- “44.1 kHz is outdated.” It isn’t inferior for music production.
- “Upsampling adds quality.” It doesn’t add any detail.
For the broader picture, see sample rate vs bitrate and 96 kHz for a home studio.