Scarlett 2i2 setup in short
The Scarlett 2i2 is a USB audio interface with two inputs, two line outputs and a headphone jack. It’s powered by USB, so it doesn’t need a power adapter. To set it up, connect it, install the driver if you use Windows, wire your microphone or instrument, set the gain, and select the 2i2 in your DAW.
Check which generation you have
Focusrite has released several generations of the 2i2, and the features and software differ between them. The 4th Gen (2023) uses USB-C, supports 24-bit/192 kHz recording, and adds Auto Gain, Clip Safe and a second Air mode (Presence and Drive). The 3rd Gen has a smaller gain range and fewer of these features.
Check the label on your unit, or Focusrite’s support page, to confirm your generation and the control software it uses.
Connect and install the driver
- macOS: the 2i2 is class compliant, so no driver is needed.
- Windows: install Focusrite’s USB (ASIO) driver before you first use the interface, and restart if the installer asks.
- First plug-in: the 4th Gen may show up as a drive with a link to register and download software.
On the 4th Gen, Focusrite Control 2 handles settings such as the direct-monitor mix, Air and Auto Gain. Check Focusrite’s support page for the control software your model uses.
Wire the inputs and outputs
- Inputs: the two inputs are XLR/TRS combo jacks. Plug a microphone into the XLR side.
- Guitar or bass: plug into the 1/4-inch jack on that channel, and press the INST button for that channel.
- Outputs: the two balanced 1/4-inch TRS line outputs go to your monitors. The headphone jack has its own level knob.
Phantom power
The 48 V phantom power switch covers both channels at once. You can’t set it per channel. Turn it on only for condenser microphones, and turn it off before you unplug anything. Dynamic microphones don’t need it.
Set the gain
On the 4th Gen, Auto Gain listens to about 10 seconds of playing and sets the gain for you. The halo rings around the gain knobs show the level: green is good, amber means you’re close to clipping, and red means the signal is clipping.
On any 2i2, you can set the gain by hand. Aim for peaks around -12 to -6 dBFS in your DAW.
Set up your DAW
In your DAW’s audio settings:
- On Windows, select Focusrite USB ASIO.
- On a Mac, select Scarlett 2i2.
- Start with a buffer of 128 to 256 samples for tracking. Raise it if you hear clicks when you’re mixing.
Monitoring
Direct Monitor sends the input straight to your headphones or monitors with no delay, which suits tracking. For the trade-offs, see direct monitoring vs software monitoring. If you’re also monitoring through the DAW, turn Direct Monitor off. Leaving it on while monitoring through the DAW doubles the sound.
Common beginner mistakes
- Expecting per-channel phantom power. The switch covers both inputs.
- Turning up the monitor knob and expecting a louder recording. The monitor knob changes only what you hear. The recording level is set by the gain.
- Assuming the 2i2 records one microphone. It records two mono inputs, so you can record two sources at once. For that setup, see how to record two microphones at once with one audio interface.
- Leaving Direct Monitor on while also monitoring through the DAW.
Where to go next
- For monitor connections, see how to connect studio monitors to an audio interface.
- If the 2i2 doesn’t show up in your computer, see audio interface not detected.
- For the full setup path, including buffer size and effects loops, see how to set up an audio interface for home recording.