Yes, you can plug a guitar pedal into an audio interface
Connect your guitar to the first pedal, chain the pedals, then run a cable from the last pedal into your interface’s instrument input. Use the input labelled Hi-Z or INST, not the line input. Then set the level and listen back.
Connect a pedal chain to the instrument input
- Use a mono 1/4-inch TS instrument cable. Pedals output an unbalanced, instrument-level signal.
- Set the input to INST or Hi-Z on the interface. Instrument inputs are high impedance. The exact figure varies by interface, but it is often around 1 MΩ.
- Buffered pedals, such as many Boss and digital pedals, are usually easier to drive. Fuzz and true-bypass chains can be more sensitive to the input, so test your chain.
- For a stereo pedal, such as a reverb or delay, use two inputs and pan them hard left and right.
Set the level
Aim for peaks around -12 to -6 dBFS. Boost pedals can push the input harder than you expect, so check for clipping when you switch one on.
Why a pedal can sound thin or harsh
Going straight in skips the filtering of a speaker cabinet. Distortion and overdrive pedals can sound fizzy or harsh that way. Many people add an amp-sim or cabinet impulse response (IR) plugin after the track to get a guitar-amp sound.
Some pedals are designed for direct recording. Amp and cab-sim pedals, such as the Tech 21 SansAmp, Strymon Iridium and Boss IR-200, are examples.
Record pedals from a track you already have
This is called reamping. You send a recorded track out of the interface, through a pedal, and back into the interface.
Interface outputs are line level, and pedals expect instrument level, so you need a reamp box to convert between them. The path is:
Interface line output → reamp box → pedal input → pedal output → interface input → new track
Reamping is a separate workflow from direct recording. It’s worth learning once you’re comfortable with the basics.
Pedals as DAW inserts and latency
If you route a track out through a pedal and back in as an insert, the loop adds round-trip delay. Your DAW can compensate for it. In REAPER, the ReaInsert plugin’s Ping feature measures the delay. Looping through the DAW isn’t latency-free, so measure and compensate.
For how interface effects loops are set up in general, see how to set up an audio interface for home recording.
Common mistakes
- Plugging into the headphone or line output. Those are outputs, not inputs.
- Expecting phantom power to reach a pedal. Phantom power travels on the XLR pins, so it doesn’t reach a pedal plugged into a 1/4-inch cable.
- Ignoring hum from the pedal chain. Power pedals from an isolated supply, and keep the rig on the same power strip as the interface. For more on hum, see how to fix static, buzz and digital noise.
- Assuming you need an amp or a mic. You don’t need either to record through pedals. A distortion pedal alone won’t sound like a miked amp, because it lacks the speaker cabinet’s filtering.