Audio Editing

How to Trim Silence from the Start and End of a Recording

Trim silence from the start and end of a recording in Audacity by hand with Trim Audio, or with Truncate Silence, and keep the natural pauses inside it intact.

On this page
  1. Short answer
  2. Delete the silence by hand
  3. Keep only the speech with Trim Audio
  4. Truncate Silence
  5. Find where sound starts and ends
  6. Leave room at the start
  7. Batch many files
  8. Common mistakes

Short answer

To remove silence by hand, select the silence at the start or end and delete it. To keep only the speech, select it and use Trim Audio (Ctrl+T). The Truncate Silence effect can shorten silence automatically. When you use it, select only the start or end of the recording, so pauses inside the recording stay intact.

Delete the silence by hand

  1. Zoom in and select from the start of the track to the first word. Click in the track, then press Shift+J to select from the cursor to the start.
  2. Press Delete. The audio after the selection moves left to close the gap. For the difference between Delete and Split Delete, see audio editing basics.
  3. Repeat at the end. Select from the last word to the end of the track with Shift+K.

Before you delete, choose Select > At Zero Crossings (Z). This snaps the selection edges to a zero crossing, which reduces clicks at the new edge.

Keep only the speech with Trim Audio

Select the speech you want to keep, then choose Edit > Remove Special > Trim Audio (Ctrl+T). Everything outside the selection is removed. This is quick when the recording is a single take.

Truncate Silence

Effect > Special > Truncate Silence shortens silences that are longer than a set duration. Its main settings are:

  • Threshold is the level below which audio counts as silence. The default is -20 dB. A threshold that’s too high treats quiet words as silence and cuts them.
  • Minimum duration is how long a quiet section must last before it counts as silence. The default is 0.5 seconds.
  • Action sets how the detected silence is shortened.

Set the threshold just above the room’s noise floor and below the quietest speech you want to keep. A noisy room needs a higher threshold, such as -40 to -30 dB. A quiet studio can often use something around -50 dB or lower. The right value depends on the recording, so preview before you apply.

Truncate Silence works on every silence inside the selection, including the natural pauses in the middle of the recording. To shorten only the start and end, select only those parts first, or trim them by hand.

Find where sound starts and ends

Analyze > Label Sounds marks where sound begins and ends. Use it to check the boundaries before you cut.

Leave room at the start

Cutting right at the first sound can make speech sound clipped. A short pad, about 0.1 to 0.5 seconds before the first word, is a common choice, although it’s a matter of taste. Audiobook platforms such as ACX set their own room-tone lengths; see audiobook recording software.

If a cut at either end makes an audible click, add a fade of 5 to 10 ms at the new edge. See removing clicks and pops.

Batch many files

Audacity’s macros can run the same steps, such as Truncate Silence and export, across many files in one pass. Check your version’s Tools menu for the macro options.

Common mistakes

  • Using the default threshold on a quiet recording, so quiet words get cut.
  • Applying Truncate Silence to the whole recording, which shortens natural pauses.
  • Trimming too tightly, which makes the speech start abruptly.
  • Expecting trimming to remove background noise under speech. It doesn’t. For that, see improving audio quality in Audacity.

The complete guide to audio editing

Audio Editing Basics: Splitting and Exporting Tracks in Audacity
Read the guide

Keep exploring

Guides from other topics

All topics →